Ikelite DS51 Substrobe

#4044.1........$ 400

DS51 front
S p e c i f i c a t i o n s
Size ......8cm x 12cm - 3.2" x 4.7"
Weight ......0.6 kg - 1.3 pounds
Energy Rating ......50 watt-seconds
Coverage Angle ......70 degrees
......80 degrees w/diffuser
Guide # (ISO 100) feet ......56 surface, 28 underwater
Guide # (ISO 100) meters ......17 surface, 9 underwater
Color Temp ......5700 degrees K
Power Source ......4 "AA" alkaline - NiCad - NiMH
Flashes ......200 full power
Recycle Time ......3.5 seconds
Firing Modes ......TTL/Auto - 6 Manual Power Settings
Depth Rating ......90m - 300 feet

flamingo tounge
DS51 Back

DS51 Side

The Ikelite DS51 Substrobe replaces the DS50, which has been a favorite of underwater photographers the world over. In addition to incorporating all the same great features of the DS50, the DS51 provides a Manual Exposure Mode with six (6) manual power settings in one-half f-stop increments for precise illumination of subjects underwater.

The compact, lightweight and affordable Ikelite DS51 Substrobe is an excellent choice for many underwater photographers. Its digital electronics make it fully compatible with digital cameras as well as traditional film cameras such as the Nikonos. The strobe can easily switch between TTL/Auto and any of the six (6) manual power settings for complete control over lighting the subject. The DS51's intensity and angle of coverage make it equally suited for macro and general photography. The strobe's wide-angle diffuser increases the angle-of-coverage up to 80 degrees, softens the light and helps to reduce backscatter. The DS51 Substrobe's power rivals strobes twice its size, recycles in a quick 3.5 seconds, and provides 200+ flashes on a set of batteries. Much shorter recycle times and more flashes per set of batteries can be realized during TTL/Auto operation.

When connected with a sync cord to compatible Ikelite housings, or the Nikonos camera system, the DS51 Substrobe offers TTL/Auto and Manual Mode. When used with other manufacturers housings, the DS51 Substrobe can only be used in the Manual Mode utilizing the six (6) power settings.

The DS51 is compatible with the Ikelite DS Sensor and EV-Controller. When used with the EV-Controller, the DS51 Mode switch is set to the TTL/Auto setting and the EV-Controller then provides ten (10) power settings in half-stop increments.

The DS-51 Substrobe is available in the following cost saving packages with either the Strobe Arm Is or Ball Socket Arm System, and your choice of EV-Controller or TTL sync cord:

DS-125 ...digital... TTL or MANUAL
Same intensity and recycle time for the 1st or the 121st flash

#4065 SubStrobe 125 with diffuser ....... $ 700
#4066 Interchangeable NiMH pack is included
Click on the photo for COMPLETE SYSTEMS
SubStrobe 125 photo

* Full power recycle time of 1 second
* TTL, Full, 1/2, 1/4, 1/8 powers
* Fuel Gauge
* Modeling Light
* 90 degree angle of coverage
* Diffuser to cover 100 degrees
* 1.5 hr Smart Charger available
* 250 flashes per charge
* Charger not included
* Interchangeable NiMH battery pack
* Weight complete less than 3 pounds
* Size is only 3.75" diameter x 7"
* 110 watt-second electrical power
* Guide # 32 underwater (ISO 100)
* 4800 degrees Kelvin color temperature

The all new SubStrobe DS-125 features special electronic circuitry for use with the newest digital cameras, but is completely compatible with TTL film cameras including the Nikonos system. It can be used with normal or pre-flash camera systems.

The DS-125 operates TTL when connected with a sync cord or our wireless TTL Slave Sensor.

The DS-125 provides TTL or Full, 1/2, 1/4, and 1/8 power manual settings with a sync cord or our wireless TTL Slave Sensor.

The DS-125 provides ten power settings in half/stop increments when connected to our Manual Controller. This controller can operate as a wireless sensor triggered by another strobe, or it can be attached to a sync cord.

SUBSTROBE DS-200

We will not have more DS-200 SubStrobes until the end of September because of a parts shortage.

The venerable Substrobe 200 now has the newest IC chips and IGBT circuitry allowing this ultra wide and ultra powerful strobe to be compatible with current digital cameras and any TTL circuitry included in our housings. State-of-the-art electronics provide a blazing 200 watt seconds of power recycling in an incredible 1.6 seconds.

This is a high performance professional strobe with the original features that revolutionized underwater photography. Mount the DS-200 on either side of the camera and the control panel and ready light are always visible for quick confirmation and easy access. The DS-200 offers four manual power modes or can accommodate an optional #4100.6 EV Manual Controller.

The SubStrobe DS-200 delivers an even ultra wide 100 degree beam. The special "soft-lite" reflector produces softer, warmer, more natural colors. A diffuser is included to widen and soften the light even more. The built-in aiming light is more than just a target light; it is powerful enough to use as a night diving light.

The main strobe electronics are sealed from the battery compartment, and the industrial grade NiMH battery module is easily removed. No more guessing about when to recharge; the DS-200 features an LED gauge which shows the remaining battery power.

The battery door is easy to disassemble and clean. A switch lock is included to prevent accidental turning on of the strobe.
Charger not included with Substrobe DS-200

#4066.1 Smart Charger .... $ 100
#4063.5 Interchangeable NiMH pack $ 150

DS-200 SubStrobe
Control Panel

SubStrobe 200
#4062.2 SubStrobe DS-200 .... $1,000.
(includes one #4063.5 NiMH battery pack)

Strobe, Charger, Arm & TTL sync cord
See: .... $ 1400 Package

Control panel
Battery Power Gauge